1) Drafters should use a      in a section view of a mechanical part that includes the cylindrical view of a threaded hole

Subject:Civil EngineeringPrice:3.87 Bought7

Share With

1) Drafters should use a      in a section view of a mechanical part that includes the cylindrical view of a threaded hole.

1. 1. Center line
   2. Hatch line
   3. Poly line
   4. Dimension line ‘
2. The section view drawing in which one fourth of an object has been marked for removal is known as a    section.
   1. Full
   2. Half
   3. Quarter
   4. none of the above
3. In offset sections, offsets or bends in the cutting plane are all:
   1. 90 degrees
   2. 180 degrees
   3. Either 90 or 180 degrees
   4. 30, 60, or 90 degrees
4. When filling an area with a hatch pattern in AutoCAD the drafter needs to be able to

                .

4. 1. see the entire bounding area to hatch
   2. set Ortho on
   3. turn ISO grid off
   4. set the layer to Defpoints
5. To avoid having to dimension to a hidden feature the drafter can utilize a                section.
   1. Whole.
   2. Half
   3. broken out
   4. all of the above
6. Objects that are symmetric can be shown effectively using this type of section:
   1. Quarter section
   2. Half section
   3. Full section
   4. Symmetric section
7. This type of section is not in direct projection from the view containing the cutting plane:
   1. Revolved section
   2. Removed section
   3. Broken-out section
   4. Full section
8. By using a                   section of a cylindrical mechanical part the drafter should be able to show only one view of the part.
   1. Half
   2. Whole
   3. Revolved
   4. broken out
9. The following is not included in title block of drawing sheet.
   1. Sheet No
   2. Scale
   3. Method of Projection
   4. Size of sheet
10. Which of the following represent reducing scale?

 A. 1:1

B. 1:2

C. 2:1

D. 10:1